Simplicity PTO
Thanks again for responding Lew & Sam Mac. I have the pto off the tractor and will attach pictures. I also found how to set the air gap, which I have done. Air gap should be .0015 and it was about .0025. Also found instructions on checking out ohm setting and amp draw. Will try to do that in the morning. One bearing seems to be turning very hard. Neither bearing feels rough. Possibly bearing getting hot and tighter. After turning pto off, locked too tight to start back until it cools off. Sam, My tractor is 22 hp but I am not sure that is the correct pto from extreme. Thanks for all the help. Will post my electric findinggs tomorrow. Have a great evening.
Bob
|