Quote:
Originally Posted by J-Mech
Sounds like a possible fuel supply issue. Could also be the carb isn't rich enough. Don't tell me it's set where the book says to. Read the book, those settings are only preliminary.
|
Yes, I think it may be a fuel supply issue. Which one is the pilot screw on the 2182 carb?
There is a screw with a spring around it and then a screw in a similar location as the diagram shows but it is screwed in completely tight and was screwed in tight on my old carb too. If I start to loosen it while running it almost shuts off. So is the pilot screw the screw with spring (Not shown in picture below)? I did adjust that some but ran ok when it was where it first was.