[taylorjm]

Originally Posted by J-Mech

Well.... if there was, people wouldn't tap the housing. That is the best place for a sensor. Get out your drill.

Here this may or may not help. Although, you have a tendency not to listen to Sam.....
http://www.onlycubcadets.net/forum/s...4&postcount=22

Again, I'm not sure why you would insinuate why I don't listen to Sam. I have contacted him on several occasions and value his opinion and insight.

Also, just because you don't know where to look, doesn't mean something doesn't exist. For instance, just one kit on Amazon: Includes 5 Brass Adapters: 1/8 Inch - 27 NPT to (M10x1, M12x1.5, M14x1.5, M16x1.5 and 1/8 - 28 BSP. I believe someone mentioned at one point it was British threads, which is the BSP. I prefer to work smart, not hard, when possible.

https://www.amazon.com/9848-Pressure...NK36KTZZSS650S