Quote:
Originally Posted by Steve N Mi
Yes, that is the way I planned to do it. My bolt holes are deep enough but it would be easy to extend the bolt hole with a smaller diameter hole if necessary.
John Hall, the felt washers go on the spindle between bearing face and backing metal washer, 4 places. My bearings are LUTCO open flanged type;
http://www.lutco.com/ 1" ID x 2" OD ~ $10. each. There are some sealed flanged bearings by other venders - more money. |
I'm not sure if you would consider this an option or not. I just put sealed bearings on my 2182 so I wouldn't have to grease them anymore. They were about $14 a piece. Same dimensions as above with a 1/16" flange on one side. The picture shows an open bearing, but they are sealed on both sides so they don't need repacking or greased.
https://www.motionindustries.com/pro...p?sku=00118945