Quote:
Originally Posted by brewsky
Meanwhile, trying to figure out if I can save the existing button.
There is a ridge built up on the thrust button where a groove for the snap ring used to be.
Options:
1: Start the engine and use it as a lathe and try to re-tool the groove with a small file. (engine probably shakes too much while running?)
2: Use a dremel wheel and try to re-grind the groove with engine not running
(I probably shake too much for this option!
3: Eliminate the brake shoe and plate, and use a homemade wear button on the actuator arm instead
|
Why don't you just buy a new one......
$10.50 each
http://ihccw.com/pto.html