Quote:
Originally Posted by Sam Mac
Todd I'm concerned that using fuel hose for hot engine oil may lead to a hose failure. The stuff I listed is rated for 300 degree oil and 250 psi. You may be able to push the hose over the existing metal lines that come from the engine and clamp the hose. What is the OD of the metal lines?
|
In the house now, I'll check tomorrow. All I know is I told the Napa dude what I was using it for, and this is what he gave me. Don't mean it's right though.
Well I got the rockshaft out today. No, I didn't forget a pin, or bolt, it was just seized. After soaking since yesterday in PB, some BFH action, and patients if finally gave up.
Cut out the shot pins, made a couple new ones out of bolts, cut to length, just have to drill the holes and weld them in. Good to go!
free upload image
free photo hosting
image hosting no register