Expensive to buy, easy to fabricate from 1/16 x 1-1/4 flat bar from lowes. Bend material slightly outside of the radius of the blade ( you can reference the holes where the original bolted to the top of the deck if you don't have the pattern to copy ) and where the outer pc and center pcs meet ( I think that's about 7 inches or so off the back edge of the deck) cut them off,weld up the end and tack them to the deck or make up some L shaped pcs and bolt them on as the originals are. I think material is about 8-10 dollars it takes 2 lengths of the flat stock which they stock either 3 or 4 feet long ,been a year or so since I last made one so a little fuzzy on the detail.Just another option if your into fabrication !
|