On a whem, I decided to try laying out a stencil for the cat 0 "Ultrahitch". Using my layout table and tools this is the preliminary design of the cheeks, which bolt to the frame and axle tubes. I still need to chamfer or round the edges, and scribe an eighth of an inch off the outside to allow for my plasma torch tip. Ill then transfer the design to a piece of 1/4" plywood. This will serve as my torch guide.
__________________
1- 1864 Dual hyd, cat 0, axle braces
1- 1450 Dual Stick w/ power steering
1- 1200 in pieces
1- 1864 in pieces
QA36A Thrower, #1 Tiller w/ extensions, IH windbreaker, IH wheel weights, 44C mower deck, 50C mower deck, CCC 54" Blade, GT46 high vacuum deck, GT54 deck, Cub Tripple Bagger, Custom dozer blade, Custom suitcase weights, 3pt cultivator, lawn sweeper, original R-Bucket
|