Quote:
Originally Posted by J-Mech
You're adjusting the high idle screw on the governor, right?
Is the cable pulling the governor lever all the way to the stop?
Is the dash throttle maxed out?
Did you readjust the governor?
Kohler wants all their engines idling too fast. I'd slow it down.... like a lot. 5-600 idle speed is really plenty. Just enough speed you can move it around without it dying. If it doesn't have a 60" deck, I would say just fast enough to be able to kick the deck on at idle without it dying.
|
I am adjusting the high idle screw
The cable is pulling the governor lever to the stop
Dash throttle is maxed out
I did readjust the gov (that answer was at least in the op
)
Good tip, when I get her back in the shop (new garage door being installed today so shop is closed
) I'll slow her back down on idle a bit.
