[TOPDOWNRESTO]

Guys,
I converted my 1650 to dual stick with all factory parts. Up front where the two lines go along the frame how are they held in place ? The spot welded clips do not quite line up at the rear.
Could anyone provide a good picture for me please.

Also the holes I need to drill for the two couplings, I measured the ones I had and they are 7/8 OD. They are Bruning D-201 Are these the correct couplings for the QL before I drill and file holes ?

I will at some point get an angle plow setup. I need one more coupling if anyone has a good spare ( my other has been wallowed out where it previously went thru the frame ). I would just need the coupling and not the adaptor fitting.

The goal is to get it up and running mechanically perfect and next chance I get will do a bare metal repaint. After I mount the front pipes Im ready to start installing the motor and finish assembling the rest.
Thanks
Carroll