Quote:
Originally Posted by dheisler
I've been through this install process now about three times and the only for sure difference is that this time I did not fill the pump full of fluid, could that have caused my issue?
|
No. Adding fluid to the Hydro did not cause your issue. Not sure how you got it to hold fluid at all..... Oil should have ran out the back output shaft bearing.
Quote:
Originally Posted by dheisler
Only fitting that was suspect was tight when I checked it.
|
The suction line is the one that runs to the top of the unit. The line nuts aren't the only suspect items. Both the 90 deg fitting at the top, and the fitting at the bottom are o-ring type fittings. Make sure they are tight, and hopefully you installed new o-rings during one of the many times you had it out....