Quote:
Originally Posted by vr4Legacy
They can be replaced without pulling the engine. Removing the grille/hood helps a lot. I used open end wrenches on the top of the bolts and let them push against the engine/frame, then used a socket from below. It's a bit tricky getting the ones near the front QA lever out, but it can be done with the engine in. Then just us a pry bar to lift the engine enough to slide them out, and the new ones in.
|
I agree with Jason. Don't have to pull the engine. He uses an open end wrench on the top, I use a crows foot wrench, no extension or ratchet.
I'd order a couple of new mounts from;
http://ccspecialties.org/clutch_driveline_rearend.html
3/4 of the way down the page,
CUB CADET Quiet Line ISO Motor/Engine Mount Kit Per Set PN/ IH-61509-C2 Use 759-3952
and just do the rears for now.
Good luck with your project.
