Quote:
Originally Posted by R Bedell
To change the Axle Seal.....
(A) Drain the Rear End
(B) Pull the Rear End Cover off
(C) Locate the effect axle on the differential
(D) There is a "C" clip at the end of the axle
(E) Remove "C" clip
(F) Pull axle out of axle tube
(G) Remove bad seal
(H) Install new seal
Reverse your steps to restore your rear end.
New Parts:
(a) Rear Cover Gasket
(b) Hydro Filter
(c) Axle Seal
(d) New Hydro fluid - ie: HyTran
Rear end should be be cleaned out and up before reassembly.
 |
How is the C clip removed? I can't see the holes on the clip to where snap ring pliers would help. Is it a matter of positioning the axle so the holes are available?