[jbrewer]

Sounds right but wasn't right. All pins are working, input to hydro pump is spinning. I will double check this though.

I did discover that the DPO neglected to tell me that all the fins on the cooling fan were broken off.

Any next hints?

I can see that the linkage from F/R lever is working fine.

BTW, this stopped all of a sudden...there was no loss or degradation before the failure.

John



Sounds right! I'll have to go see how to tunnel cover removes and give a look see. Doesn't sound too bad.

I guess the load of pumping the PTO lift and the motor at the same time exceeded the (probably OEM) shear pin.

Back in a bit!