New driveshaft?
Who drilled the holes.
Are you using a Cub Cadet throw out bearing or an aftermarket throw out bearing?
It sounds like the holes in the drive shaft are in the right location. I've used the thicker clutch plates and didn't have any problems. You should have enough adjustment using thicker plates.
Quote:
by J-Mech
I think that clutch was a bit overkill for the application..... but whatever.
|
I'm using stock clutch plates with a blue spring and a Kevlar clutch disc on my 100. I have no slippage issues with this set up. Engine is making around 14 horse power and pulls a 10 inch plow at plow days.