[DownNdirt]

First question is what thread size bolt do i need to hold my side panels on? (Like 5/16 or 1/4 or something along those lines) I've tried looking everywhere and can't find anything on them. Second and final question is what diameter is the trunion shaft? I will eventually be pulling off my fender pan and repairing the trunion ( should have done it when i had the transaxle out but i didn't think it would be as bad as it is,) and my damper plate is fairly loose. I think I'm going to reweld the trunion, tighten up the damper plate and replace the springs while I'm in there as it seems that's where most of my creeping problems come from. As always, any answers are greatly appreciated.