Quote:
Originally Posted by J-Mech
It is hollow, but I do not believe the solid shaft is a tight fit to the hollow one. I would get a hold of Jeff in PA for some help.
|
Jon actually the 2000 series shaft is a nice snug fit to the 5/8" shaft used on most older Cubs. That's what I did on my 149 at the engine end. The 149 drive cup was shot as was the end of the drive shaft. Once I got the length as I wanted it I marked it, pulled it out of the tractor, drilled it and put a 1/4" spirol pin in it. Then I reinstalled it.
