Quote:
Originally Posted by Sam Mac
Jon actually the 2000 series shaft is a nice snug fit to the 5/8" shaft used on most older Cubs. That's what I did on my 149 at the engine end. The 149 drive cup was shot as was the end of the drive shaft. Once I got the length as I wanted it I marked it, pulled it out of the tractor, drilled it and put a 1/4" spirol pin in it. Then I reinstalled it.  |
+1 snug fit. The one I did I had to "persuade" it on with a rubber mallet.
__________________
1872 with 50C deck
1862 with 50C deck
1641 with 48GT deck
364 snow blower
IH Cub Original with deck
GREEN 317 with integral sleeve hitch, front hydraulic
|