Quote:
Originally Posted by Bluecub
Took my cub apart for paint, clutch/driveshaft, and a new engine. Lost the key so I had to replace the ignition switch. Got everything wired up per the diagram, went to turn it over and nothing happens. So I put the switch in the on position and used the jumper cable trick on the starter and it turns over fine. Would this be a symptom of a bad starter solenoid? Or even a bad ignition switch out the box?
|
Your first six words gives some indication as to where electrical problems could lie. Solenoid needs a good ground, starter needs a good ground, voltage regulator needs a good ground, battery cable needs a good ground. Did you make sure of all that before you start throwing parts at it? In addition, I can't find the correct switch (IH-60736-C2) for sale on TSC.com. All I saw were MTD switches, which ain't gonna start a NF Cub.