[cooperino]

Originally Posted by J-Mech

The hydro will be fine. Use a Cub Cadet filter, or a Wix 51410, or Napa 1410. Those are the 3 correct filters.

Make sure to plane the head before permanent installation.

John is right, the hoses really only need to be single or double braid, but hoses are pretty cheap. If you need a new pump, that's where the expense will be. Or if the cylinders leak, which is likely.

Single "braid" which is considered one wire it is for suction only. 2 wire would be for pressure up to 3400 PSI. Both hoses are available from 3/16 to 2". You could use 2 wire hose for both suction and pressure lines but 1 wire is cheaper and fine for the suction side. Figure out what ends you need and check out this site. Local hydraulic shops make most of their money on hose assemblies and tend to over charge .

https://www.discounthydraulichose.co...blies_s/74.htm