Quote:
Originally Posted by Ewilliams
I just looked at the manual and found the friction adjustment on the hydro handle. I will adjust it tomorrow. Thanks again for all your help.
Earl
|
There should be a friction bushing in there too. It was almost gone on my 149 and the bolt was tightened all the way down. They are available from the sponsors. I'm cheap and didn't want to pay the shipping, so I wrapped electrical tape around the outside of the bushing to thicken it up and cranked er down as a temp fix. Seems to be ok 2 years later.
__________________
-Jason
Cub Cadets: 1200 | 149 | 1650 | 122 | Z-Force S 54
Implements: QA42A | Push Blades | #2 Tiller | Rear Blade | 223A Utility Trailer | And a few mower decks
Gravelys 5260 | CI Walk-behind (Project)
And a couple of Subarus
