[cnewell]

Looking for experience and opinions on how the clutch pedal return spring is supposed to be connected to the rod. I’ve seen a couple different ways and the manual diagrams don’t seem to be helpful. Is the end of the spring supposed to loop through the small hole on the end of the rod or is the circular curved portion of the spring supposed to slide over the end of the rod with a washer and cotter pin to hold it in place? Looping the actual end of the spring through the small hole seems like a good way to wear out the hole (as it is on mine currently). Sliding the spring over the rod and using a washer and cotter pin seems like it would reduce wear and keep tension better. Curious what you all recommend. I haven’t seen enough of these yet to make an informed decision.

Thanks!