[cooperino]

Originally Posted by Lonstar

Judging by the pics Jeff provided (thx Jeff) it looks like the glass is held in with a single piece gasket. Did some searching and read about them. Found opinions that vary from extremely difficult to remove/install to pretty easy to remove/install.
I'm going to give it a shot. Even though the rubber looks to be in good shape it's probably less pliable than new rubber and shrank over time, so I'll replace it with new. Plan is to lean a panel against the wall for a while so the baseboard heat warms it up, then use some hot soapy water. I'll cut it as needed to make sure I'm not putting any stress on the glass as I go.

Should be easy, right? (sarcasm)

OK.. if your buying new gasket it makes it really easy.. Just cut through the middle with a razor all the way around. By time your half way around they usually fall out.. Be ready to catch it.