[sorner]

While blowing snow this morning, more like slush, I had a clog so I lifted the blower to clear the clog and my lift rod that goes from the lift arm to the blower turned into a U and knocked the side panel off the hood from the extra weight of the jam of slush and snow. I was able to get it off and heat it with a torch, and hammer bend it back relatively the way it was and I almost got finished and it bent again. Clearly it’s weakened now. I’m thinking I might have one made. Is it anything special metal wise? I seems hollow. It also seems like it should have some reinforcement at the factory bend. Because that’s where it kinked.