Quote:
Originally Posted by Alvy
All good advice.
I will add to make sure your 1/8” Allen has sharp edges and Don’t use the socket with the little ball deal on the end because it will snap off. Patience and PB blaster are your friends. You might have some that break loose but then get tight again. Go back and forth with those as the exposed threads are rusty after many years. Back together with anti seize on the threads. Make sure to thin out. 7/16 wrench to make sure you can lock the lock nuts together because they will cause problems if loose. Good luck.
|
I also like to blow the dirt and crud out of the holes prior to soaking with PB ( if you have air available ) protect your eyes !
