View Single Post
  #1  
Old 05-21-2019, 07:05 PM
ScottB ScottB is offline
New Member
 
Join Date: May 2019
Location: TX
Posts: 6
Question 2016 XT1 Enduro Series 50" dies shortly after engaging blades

Hello, all!

I'm new here, but have been reading a lot on these forums. Good info, for sure.

Here's what I have:

Cub Cadet XT1 Enduro Series w/ 50 inch deck (model 13AQA1CQ056)
Engine: Kohler PS-KT735-3058

What I've done:
New Fuel
New gas cap
New fuel filter
New fuel pump and fuel lines
New carb.
New ignition modules
New air filter
New Spark Plugs
New oil filter w/ oil change
New Battery
Also new Spindles, Blades and deck belt.

It runs fine without load, but once I engage PTO (electric) I can mow for a short distance before it dies. It is tough to restart right away, but after a minute, I can start it and drive it back to the garage. It may or may not die while driving it back to the garage. Inconsistent.

This was happening before I swapped out all the stuff above. I can mow for a minute or so longer now than before I changed everything out, but still having the same problem.

Please help. I don't know what else to do, other than lower the mower onto my head to put an end to it all. (kidding, but seriously. I'm at a loss here.)

Thanks!

-Scott
Reply With Quote