Quote:
Originally Posted by _DX3_
If I am not mistaken and I will check my manual later to double check, but the coultier only needs to make a 2 to 3 inch cut. What you will probably need to do is make a pull with the plow with the tractor tires down in a previous furrow to be at the correct angle. Stop your tractor, leaving the plow down and visually see and measure how deep the coultier is cutting. If it is too much raise it, if not enough lower it. That will also be a good time to make sure the plow is pulling straight and cutting straight. If not you can make adjustments.
|
I understand that. And it is set at the correct depth. But, I can move the whole assembly (when loose) like a pendullum from 5:00 to 7:00, and this changes the distance between it and the share.
My question is: "Should it almost touch the share, or should I be able to wrap my hand around it and the share?".