[lwrehm]

I tried asking this on Facebook and now I'm more confused than ever...maybe I will ask better here.

I picked up a new voltage regulator and wire harness for my 149, I was going thru the connections here at my desk and nothing appears to line up between the notes on the wires, the terminals on the regulator and the wiring diagram.


I have 3 wires coming out of the harness that are labeled "voltage regulator". The tag goes on to say Gray-"Batt", Blue-"A", Yellow-"F"

The diagram I have (from Technical Doc section) shows a Gray wire going to "B", Blue wire going to "G" and a Yellow wire going to "F"

The Voltage regulator has a "GEN" terminal, an "F" terminal, a "BAT" terminal and an "L" terminal


From this I'm fairly confident that the Yellow wire should go to the "F" terminal.
I think the Blue wire should be going to the "GEN" terminal and the Gray wire should be going to the "BAT" terminal, but not very sure about this...and I have no clue what "L" is for.