Quote:
Originally Posted by MrRazz
Hi all, i just installed my snowblower on my 1250 for the first time. It wasnt exactly easy but with some help from my wife we got it on but it doesnt seem like its lifting up very much. Its only lifting enough to get the very bottom about 1/2" to 3/4" off the ground. I think my lift bar is 28" long which i believe is the correct one. Maybe someone has some knowledge on this and can help. Thank you.
|
Four questions for you MrRazz, which the answers to may help pin down your problem:
#1. Have you made sure that the "Lift Stop Cam" is not set at some point where it is limiting the travel of the lift?
#2. With
NO "lift rod" installed in the "rock shaft lift arm", does the "rock shaft lift arm" travel through it's full range when you operate the lift? (i.e. more than 1/2" to 3/4")
If the answers to #1 and #2 are showing full travel of the lift then....
#3. With
NO lift rod installed, can you physically move (i.e. grab and lift) the thrower unit more than an inch off the ground?
#4. Have you gone to the Technical Library on this site and downloaded or read the "Operating and Setup Manual" for your particular snow thrower?