I got everything I needed from the dealer besides the bearings I got from the local car quest. I had to fix the right rear corner where the bracket for the idler wheel welds onto the deck it was all rotted out. Cut out the bad and welded in new. It seems to work great! But when I lift it the left side is down 1-2” lower then the right. Low enough that the idler wheel always touches the ground. It isn’t to big of a deal I can lower it down and sit it right on the wheels to mow. But is this a common issue on them? A simple fix or tweak to get it to raise level so I can use the stop instead of sitting it down on the wheels?
|