[northernredneck]

So I'm looking for some advice. I'm trying to remove the pto clutch on the front of one of my K241. So the PO somehow put the pto clutch on so that the set screws were not lined up with the cut outs on the clutch basket if that makes sense? So I was able to get 1 of 3 set screws out. The other 2 as far as I can see are completely stripped out. So in anyone elses expirence do I drill out the other 2 or just cut my losses and bust out the cutting wheel to get it off the crank shaft. I have a mower deck I wanted to use for this but will be my daughters ridding/working tractor so it's not absolutely necessary to have the clutch. I will be a pearl black with pink accents so the deck may look funny on it anyways.