[mik125]

Hi, I got an old CC125 on jackstands in my garage. I removed the hydro valves because they were stuck closed. I cleaned them up and got them sticking out again but they would likely stick again if I use the lever box.

However, with them in the out position, I can spin the rear hubs by hand. It like I need to prime it. I have no idea on how old or how much fluid is inside. The control lever doesnt allow them to spin but the linkage moves although the fat small spring attached looks like it seen much better days.

Am I supposed to do something to prime the system after removal of the valves? And am I able to that with the tractor on jackstands?