Used Cub#2 with mower to take measurements and check clearance.
Decided to do 2000/3000 driveline upgrade to gain additional clearance. Already had a #3093 driveline on hand. Originally plan to install in Cub 2 since this tractor mostly does pulling. Cut the end of the 3000 driveline and turn off the weld with the lathe. The ID of this driveline is 5/8” which the flex disc joint 5/8” OD driveLine perfectly slips into.
By the way, most of this information is not originally my ideas but a consolidation of other work. Will go back later and give credit to those who contributed.
|