[tinklevision]

Hello.

So after spending way too much time, I finally found the cause of the hydro leak on my tractor, it is from the shaft seal on the rear of the hydro pump.

I have replacement seals (got one for the front also) along with a replacement gasket.
However, I cannot for the life of me figure out how to prize apart the two halves of the casing. All bolts have been removed, but its steadfastly refuses to separate. Any ideas?

Also wondering what I will find once I do manage to take apart.
Am now wondering if I just take this to a repair facility and have them do the work.

Love to hear your thoughts.