Quote:
Originally Posted by sonofsquink
Just for reference, that center brass jet is what I stripped and ultimately destroyed. I don't think that something that can just be plugged so a word of caution to any other newbies out there
|
That "jet" is the emulsion tube.
Try recutting the slot carefully with a hacksaw or small jewelers file.
Then reinstall it.
I understand you enlarged the bored hole with an easy out, but after it is installed, and the bowl retaining bolt in installed in the threaded casting under it, the fuel is sucked out of the fuel bowl through a small drilled hole in the side of the threaded casting above the bowl bolt, and below the emulsion tube.
IIRR the main adjusting jet is down stream and should negate any enlarged hole in the emulsion tube.
You have nothing to loose trying that.
I would suggest you use your other carb. to get the engine operating correctly, then try your "modified"
carburetor.
Do let us know how it turned out