[Bryan S]

Originally Posted by aagitch

Looks like a 42" blade and it will fit a 1863.

Yes 42"

Originally Posted by bugeye

At $60, I would say a good buy if the edge is not worn away or plow perforated by rust. Looks just like what I use on my 1863 and 1864. If you want to drive to Reading, You may compare to my plow.

Not rusted very much at all. Bottom edge minimal wear.

Originally Posted by R Bedell

I agree, it "appears" to be WF Dozer Blade. Can't say for sure without a "side shot" of the Sub Frame. You can take a Tape Measure and measure across the front of the blade to determine size (ie: 42" or 54").

It's a 42" blade. Roland, Do you know if these were stamped
or tagged with the model numbers. Eyes terrible, def no tag but
no stamp either from what I can tell.

Originally Posted by darkminion_17

That will fit your tractor, But it looks like it is for an 82 series. Didja get the lift rod and the bracket that attaches to the rock shaft?
Picture of correct 1863 bracket.

Yes got the lift rod with it, but no bracket for the rock shaft. Here's a few more pics.
Thanks to all for the help.
I'm trying to get an 1863 to use as
my plow tractor so appreciate all the help with this.
My memory is not so good.. Need too remember to write stuff
down when I get them, but remembering too write stuff down is a
problem with me as well.