782D Wiring ?
I tried to post a new message but apparently don't understand so hope you can direct me and maybe guide me in the following.
Hello,
The following is in reference to a red 782D Cub Cadet with the 3 cylinder engine.
Today, I replaced the roll pin under the battery box that supplies power to the drive wheels by means of the steel rod. Of course, I removed the battery and the battery box attempting to get to the broken pin. Finally, I was able to remove the broken pin and install a new pin.
After reinstalling the battery box and battery, the engine started with no problem. However, when I flipped the toggle switch to engage the PTO to turn on the blades, nothing happened. I looked to see if I had disconnected a wire in my previous task. I could find no wire that had been disconnected and decided to turn it off for a further examination. Still unable to locate any loose wire, I attempted to start the engine and nothing happened. No clicking of the solenoid or anything.
I contacted my nearest dealer and they don’t seem to have any wiring blue prints.
I was sure a wiring diagram had previously been put into a file in the computer but was unable to locate any.
Certainly would appreciate a wiring diagram and any guidance.
Thanks
|