Quote:
Originally Posted by West Valley G
Yes that is correct. Take the .002 undersize crank and grind it .010
under and buy another rod to fit that. No problem, clear as mud on this
end . Have been buying parts from the guy that you linked. Been just
fine so far.
Ken
|
remember .010 under from the factory spec not .010 plus the .002 it is already under size, finished journal should end up 1.490 plus or minus .0005 like george says best to take the new rod to the shop with the crank unless you got a good set of mics at home and are good with them !
