48” 3 spindle deck
As I’ve finally gotten my tractor running pretty well I’ve began tackling the mower deck that I got with it. I got the blades off after lots of PB blaster and a very good impact. I’ve got the spindles apart from the deck and I’ve began disassembling them, however I’m confused on how to check the condition of the spindles and bearings. I’ve got the pulley detached, the spindle is in two pieces. I see two rubber seals on each end of the “main” spindle piece, and that’s as far as I’ve gotten. Is there a way to further disassemble these? Replace seals, bearings etc? How do I tell if a replacement spindle is needed? If one is needed how do I find a replacement?
|