Quote:
Originally Posted by 1711Cub
I changed the oil using OEM Kubota filter and oil, filled to the 98.4 OZ spec. The oil light did not work at all. I hooked it up, and it stays illuminated until mid throttle then goes out. I'm going to replace the sending unit, and see if that corrects it. Otherwise I will need to dig deeper to fix the low oil pressure. Thinking that the relief valve could be hanging up. Now I have read that on some older Kubotas, the aluminum cam plugs fall out and cause a low oil pressure condition. Not sure if this applies to these D600's or not..
Also, I managed to shear off a driveshaft pin on the engine end just driving it around my property. The hydro end has a cheap bolt in it. I ordered two spirol pins to replace both ends.
|
Roland uploaded the Kubota service manual for your engine in the reference section here.
__________________
Why Farm Half When You Can Farmall?
1282 | 44C Deck, 42" Blade, 020" Over K301 * 1711 | 50C Deck, #1 Rototiller w/ Extensions, Sleeve Hitch, CH18S * 1811 | 46 GT Deck, 42" Blade, M18, Sleeve Hitch * 1782 | 60" #375 Deck, Kubota D640 Diesel * 1862 | #450 Snowblower, M18 Magnum * 782 | Y/W KT17 Series II, Sleeve Hitch * 984 | Y/W Onan/Linamar 20HP, Sims Cab, CAT 0 3 PT w/ Rear PTO, 60" #374 Deck * 1914 | 44C Deck, KT17 Series II * 127 * 1650 Twin Stick | 50C Deck, 42QA Snow Thrower, K341 * 1862
|