[sorner]

I’m trying to install this 364 snow blower on my 1912, I figured out I’m missing some parts. I downloaded the manual from here. I’m missing the guide bracket for the front which is no big deal, a couple pieces of angle iron and a bar and I think I can make one. I put the belt on but the alignment of the main pulley and idler pulley is a little off from the PTO pulley. The manual says for some tractors (not mine) to turn the idler pulley around. It was last used on a 1711 so I think it should be in the right orientation to fit my 1912. It is repowered with a Kohler M20, so it should fit the same as the 1711 I would think. Anyone have any ideas/suggestions?