Hello again. Before I get started I just want to say how thankful I am for the help I have received on this forum.
I have made a little progress on resurfacing the cylinder head off of my IH Cub Cadet 70 since my last post. However I noticed low spots around the edges and did my best to circle/outline them in the below picture. I didn’t notice them until now.
Also, in a previous post it was recommended that I use 150-180 grit sandpaper instead, but is that even worth it considering how far I am?
https://www.onlycubcadets.net/forum/...pictureid=8280