[Stitch]

I got an IH blade last week. It runs all the way under the tractor to the trailer hitch spot and attaches there, and then hes two arms that are meant to attach to my deck lift arms underneath. The problem is the entire blade assembly appears to be a little long, so the lift arms don't match up quite right. I currently have them hooked together with chains to keep the blade straight and have been using rope to manually raise and lower the blade.........but this ..............sucks.


Is there anything anyone has done to fix this problem aside from cutting the blade assembly and welding it back together 3 inches shorter?

I'll post pics in a few minutes.