How much clearance is behind the bushing?
I use to work at a rebuild shop. We rebuilt lathes, mills, grinders, all machine tools. If they needed to remove a bushing in a blind hole: 1st they would make a shaft the same size as the bushing, very tight fit. Next pack it with grease and leave some room to start the shaft in the bushing. Then they would beat on the shaft with a mallet. If there is clearance in the back of the bushing and it is a blind hole, the grease will push the bushing out. I was amazed thr first time I saw it done.
Not sure if this will work on this application but it might.
__________________
1572, 1864 x2, 1810 x2, 1863 & GT1554(Dad's Ole Mowers), 1811,782D, 1872 x2, 782DT(Sold), 3235, 1860, 1772 with 3-point and Turbo.
|