Alright, I finally got back on this project today. I got it to fire up and run for 15ish minutes. I replaced and set the points, and adjusted the carb as the manual says to do. I got it to run and it ran fairly good. However after it got warmed up it just died, no backfire and sputtering. The only way I could get it to run after that was with Carb Clean.
I’m going to try it tomorrow after it’s cooled down to see if it might start cold.
I checked and it did have good fuel flow and spark after it quit. I would think if the gas was bad it wouldn’t have started in the first place.
__________________
Currently
1971 International Cub
1976 Cub Cadet 1000
1982 Cub Cadet 1282
And a few of other brands!
|