Okay, I'm pretty sure I need to pull this new seal and trash it but I'll ask anyway.
I was installing a new oil seal behind the pto and drove it in too far and not straight. The manual says to drive it in 5/32" +3/64" -1/64". So if my math is correct that should be a max depth of 0.203". The 2nd pic is where I ended up at. I'm worried the 0.287 (at the 10:00 position) could possibly be covering the hole feeding the rest of the engine of oil but I don't remember where the passage is. Do I just drive it in straight or just pull it out and replace?
IMG-7082.jpgIMG-7086.jpg