View Single Post
  #2  
Old 05-13-2024, 09:16 PM
athomas's Avatar
athomas athomas is offline
Senior Member
 
Join Date: Dec 2011
Location: New Florence, PA
Posts: 566
Default

on the one end the bearing plate comes off and the bearing slides off the crank with it. then you can slide the crank out of the block and the other brg will stay in the block but to answer the question yes the crank will slide off the brgs it's a close tolerance but not an interference fit as would be if you needed to heat the races to get them on . if that answers your question ?
Reply With Quote