[Sergeant]

Originally Posted by spndncash

Ok so I had, and long lost, the shield from the right angle drive to the tiller belt. I have not seen the shield for about 15 years. I have never had any issue. advice: dont stick your fingers in the operating equipment.
I am completely unaware of the hang off the transmission anti belt floppy thing you guys mention. I have one pully on the motor, two to change directions to send the belt under the tractor and the one on the right angle drive in the rear. I dont have any other pulleys and my belt does not flop around. it has had the same drive belt for at least 25 years and I use the tiller every year. the secondary belt broke last year but I had never bought one of those either. I have had this tiller since mid 90's and I used it every year with this same configuration.
I am running this on a 106 with a danco front end loader

He is Looking for a 56-571-C1 Hydro Belt Guide or a 485-300-R1 Gear Belt Guide shown In the Diagram below circled In red