Quote:
Originally Posted by spndncash
it has been some time since i rebuilt a creeper. I believe the yoke and the shift collar are both asymmetric. if they were installed backward I believe they will not fully engage in one of the settings Hi or Low. I dont recall there being a neutral on these. I would think "neutral" is a mid position not an actual designed selection position.
|
The shift collar only goes on one way. Did you remove it? As for the shift yoke, it does not matter, but if it is severely worn it will not stay in gear. The detent may also be an issue, the roll pin hole that is in it may be egged out.