Got the leak down tester and found quite a difference between cylinders. 12 percent on number 2 cylinder and 23 percent on number one. So I took number one apart and found the rings were only seated on 2/3's of the diameter on the upper two rings.
I did screw up on the stones of my new hone. I used the course stones to finish with. Should I thake the other cylinder apart and re hone with the fine stones? I have done this on number one and am still within tolerance just barely.
I did also measure the rear seal outer diameter. The one from lil red barn does not have a brand on it so I assume it is a chinese import. It measures .012 smaller than the NOK that came with the other gasket set.
|